Embroidery Designs Select From Pull Down Menu

Mixer Cover Pattern Designed to  Fit Kitchen Aide Mixers

Courtesy of Renee Ann Wirick

Mixer Cover Photos source: Julia's Needle Designs Yahoo group (photo album)

Click on Mixer For Free Design

 

PROJECT INSTRUCTIONS FOR YOU:
Supplies Needed:
One yard of pre-quilted fabric
Thread
Rotary cutter and mat
Scissors
 

Print out round section of pattern. (CLICK HERE)
Cut one piece of fabric 32" by 14". (For the 4-5 quart mixer) Mark the center of the long side.
Cut one piece of fabric 34" by 14". (For the 6 quart mixer) Mark the center of the long side.
Cut one piece of fabric 9" by 16". (For the 4-5 quart mixer) (this is for the front pocket)
Cut one piece of fabric 10" by 17". (For the 6 quart mixer) (this is for the front pocket)
Cut two of pattern piece B (rounded edges)
ADD 7-8" TO THE BOTTOM OF THE PATTERN PIECE BEFORE CUTTING OUT THE FABRIC FOR EXTRA ALLOWANCE..  
Mark the center top.
Front Pocket Section.
Turn under top of the pocket section and hem one inch. Embroider your design now.
Place pocket section wrong side down on the right side of long piece.
Center and line up the raw edges. Serge or conventional sew down the sides.
Match the center of the long section of fabric with the center marking on the rounded pieces.
Sew the sections together from the top to the bottom edges. (use conventional machine or serger)
Repeat for both ends of the cover. Trim off any uneven edges if necessary. Turn under bottom edge and hem 1" inch.